XCLP3 Series Precision Hydraulic 4-Column Plane Cutting Machine

1. The machine is widely applicable for cutting of nonmetal materials in various industries by die cutter.
2. Adopt double oil cylinder, precise double-crank connecting rod mechanism, which can guarantee that the cutting depth at every cutting position is same.
3. With special setting mechanism, and equipped with die cutter and cutting depth setting, the travel adjustment is simple and accurate.
4. The pressing board of cutting carries out slow cutting when it contacts the die cutter, which can make that there is no size error between the uppermost layer and lowermost layer of cut materials.
5. The central oil supply automatic lubricating system guarantees machine precision and prolongs service life of machine.

Main technical parameters:

· Double balance is performed at the four corners of the machine using 4 guide posts and dual flexible arms so that the balance is accurate and the pressure in the middle of the working table is the same as that of the edges.

· All sliding parts are lubricated with oils supplied by the hydraulic system so that service life of the machine is prolonged.

· External oil pump, motor and electrical box allow for ventilating and cooling conditions as well as prolonged service life.

· In the absence of heat source, the hydraulic oil is of low temperature and never deteriorates, therefore extending the service life of the sealing element.

· Due to short, small and few balance points, there is wide pressure differences between the center, the edges and two sides of the working table, leading to the situation whereby the center is cut while other parts are not when cutting.

· Due to lack of adequate lubrication and few balance locations, abnormal wear may develop on single side of the balance post and can not be repaired.

· The bar and the beam are usually stretched broken at the center of the their two ends during the use of the machine.